SKU: 49913360555
Ships within 48 hours · Estimated delivery Sep 6 - Sep 11
Internal clamp diodes
1\" header or a 4-pin JST PH connector
The sensor can be used with microcontrollers like Arduino UNO to measure the flow of liquids with high concentration and low viscosity like water
Charging is done by a USB C port on the side of the bank and charges at 5V 2A
just power it up without sending any commands
Gravity: Analog Turbidity Sensor for Arduino Shipping:1 day Internal clamp diodesThe Arduino turbidity sensor detects water quality by measuring the level of turbidity . It is able to detect particles in water by measuring the light suspended transmittance and scattering rate which changes with the amount of total suspended solids (TSS) in water. As the TTS increases, the liquid turbidity level increases. You may also check Liquid Sensor Selection Guide to get better familiar with our liquid sensor series. This Arduino turbidity
US$ 34.97
US$ 32.50
US$ 22.00
US$ 60.00
US$ 20.00
US$ 83.30
US$ 45.50
US$ 21.00
US$ 146.30
US$ 107.50
US$ 19.00
US$ 35.00
US$ 45.50
US$ 35.00
US$ 50.00
US$ 50.00
US$ 47.50
US$ 44.10
US$ 194.00
US$ 51.10
