SKU: 81681733512
Ships within 48 hours · Estimated delivery Sep 5 - Sep 10
Drive Mode Tune for Speed Control
If you plan on using this connector with a custom PCB make sure to check out the Datasheet in the _Documents_ section below for mounting dimensions
Only one input and one output are allowed to be connected at the same time
The regulator is enabled by default: a 100 kΩ pull-up resistor on the board connects the ENABLE pin to reverse-protected VIN
0V minimum logic-high
Conductive Stainless Thread (9Ω) Motion Sensors Drive Mode Tune for SpeedThis is a smooth stainless steel fiber conductive sewing thread. It features small resistance, good thermal conductivity, high melting point and high temperature resistance. One roll has 7m sewing thread, and about 9per 1m. The diameter of the wire is 0. 45mm. It can be used for making touchscreen gloves, anti static clothing, wearable electronic equipment, anti static brush, driving LED and other small current electronic components. Note: the thinner
US$ 133.50
US$ 151.50
US$ 53.40
US$ 40.80
