TPM - Wash Solvent - 5L 3DE ASA+ - 1.75mm * Installs much easier than

* Installs much easier than masking tape and film typically used and with less chance of air bubbles

Wide range of color options

Desuden giver den dig alle de nødvendige data til optimal styring af alle processer og indstillinger

abrasion-resistant

this makes ApolloX a perfect technical filament for outdoor and automotive applications

TPM - Wash Solvent - 5L 3DE ASA+ - 1.75mm * Installs much easier thanWash Solvent TPM Wash Solvent (Tripropylene glycol monomethyl ether) is a non flammable, low odor solvent that can be used to clean and dissolve uncured resin on SLA DLP 3D printed parts. TPM has a lower evaporation rate than IPA and washes about three times as many parts as IPA before it needs to be replaced. * Compatible with Formlabs Finish Kit, Form Wash and Form Cure * 5 litres ! ATTENTION ! TPM is not currently certified for use with Formlabs