SKU: 19361724581
Ships within 48 hours · Estimated delivery Sep 2 - Sep 7
This set of taper roller bearings is designed to replace the original set of steering stem bearings on an R 100 CS for the years shown above
The coil is 55mm centre to centre mounting with 1 spade connector
If the readings are above what your manual states (commonly no greater than 15 volts but can vary from bike to bike so check your manual) then please remove the rectifier and contact us directly
Yamaha YT 60 Tri Zigner (Trike) (1984-1985)
Yamaha IT 250 (1978-1983)
CDI Immobiliser Bypass: Gilera Runner ST200 ST 200 Aprilia RX125 This set of taper rollerBrand New CDI Immobiliser Chip Key Bypass unit to fit: Gilera Runner ST 200. To replace Magneti Marelli CDI units stamped ACI600 ACI601 ACI602 ACI603 ACI604 units or EFI Technology units stamped AC2i AC3i AC5i AC8i. Please note other CDI Immobilisers may look similar but the original CDI must have one of the AC numbers mentioned above stamped on it for this to fit. Simply plugs straight in to the existing wiring loom. No wires to cut, no soldering,
US$ 132.93
US$ 199.90
US$ 114.95
US$ 139.93
US$ 59.00
US$ 49.99
US$ 179.90
US$ 107.94
