Simpson HWSC6-KT 5-3/4 in Head-of-Wall Slide-Clip Connector 16-Ga Galvanized w/ Screws 50-Pack ECCLQ End Column Cap L-Shaped What material and finish does

What material and finish does the ECC74ROT use

Hot-dip galvanization (HDG) provides an extra layer of corrosion resistance

this hoist gives operators precise control over every lift - moving loads quickly when needed and slowing to fine-placement speed with a single button press

these finishing nails are purpose-built for clean

Useable Length : 4-1/2"

Simpson HWSC6-KT 5-3/4 in Head-of-Wall Slide-Clip Connector 16-Ga Galvanized w/ Screws 50-Pack ECCLQ End Column Cap L-Shaped What material and finish doesThe Simpson Strong Tie HWSC6 KT is a 5 3 4 inch Head of Wall Slide Clip Connector engineered to simplify the panelization of printed studs used in off site and panelized framing systems such as FrameCAD, Arkitech, Howick, and Pinnacle. Rather than relying on slotted track which is notoriously difficult to panelize the HWSC is designed to replace slotted track with a typical printed track at head of wall conditions, streamlining the construction